- Incorporates a blend of polyethylene resins, polymers and sun screening agents to form a protective barrier against exposure, inclement weather, heat, and ultraviolet solar rays.
- A protective coating without the extreme and difficult problems of removal that most products of this nature represent.
- Recommend use of either pressurized or siphon spray gun as an applicator. When spraying, do not to exceed gun pressure greater than 40 PSI. Adjust fan to desired width over a pre-cleaned surface. Spray one coat; allow it to dry. Cross spray, allow to dry. Spray flow coat to desired thickness for proper coverage.
REMOVAL: On molds that have been exposed to weather conditions and have become coated with dirt, dust or grit, hose off entire mold to remove debris prior to washing and wiping. Wipe with cloth or wash with simple soap solution under agitation. In extreme cases, wipe down with with FK’s #69: Mold Cleaner & Stripper to remove the wax. Re-wax the mold by reapplying one or two coats of wax release agents and then place it back into production.
